FREE SHIPPING IN AUSTRALIA OVER $75

0

Your Cart is Empty

Spunding Valve | Adjustable Pressure Relief Valve

4
Size Guide

See the newspunding valve here

A spunding valve is an adjustable pressure relief valve with a gauge attached to show internal vessel pressure.

They are most commonly used to do keg to keg transfers of carbonated liquid under pressure.

To do this attach your regulator to the full vessels gas inlet post (fermentasaurus for instance) then join the 2 liquid post together with 2 liquid disconnects and a length of beer line.

Attach the spunding valve with a gas disconnect to the empty vessel (mini keg for example). 

Set the pressure on the regulator to 12-15psi and then unwind the spunding valve until gas begins to vent (unwind the end opposite the plastic disconnect to adjust pressure release point). Set pressure to 8-10psi on it and the liquid will transfer across under pressure without losing any carbonation.

It can also be used to set a release point for pressure in the fermentasaurus, this is very useful as you can set it to approx 12 psi (depending on fermentation temperature) and once finished the beer will already be carbonated (you will need to either chill the fermenter to allow the liquid to hold carbonation while you bottle or use the method outlined above to tranfer under pressure to stop it losing the carbonation while warm though.

Customer Reviews

5 Based on 4 Reviews
5 ★
100% 
4
4 ★
0% 
0
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Write a Review Ask a Question
  • Reviews
  • Questions

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

    A
    19/11/2018
    Anonymous
    Australia

    Sounding valve

    My experience with the sounding valve has been terrific, very handy and gives good control over word pressure. Just be sure to order a disconnect that goes with it - otherwise it's pointless.

    A
    28/06/2018
    Anonymous
    Australia

    Spunding valve

    At first a bit of fiddling had to take adjusting valve off and turn the part around inside that at least made it work David was helpful when I rang him and he said he would replace it But all good now cheers

    DT
    06/03/2018
    Damien T.
    Australia

    Spunding valve

    Needed this to fill a keg from my fermentasaurus. It’s a bit fiddle to set but works well.

    SG
    14/02/2018
    Steven G.
    Australia

    Great

    Prompt delivery was very pleased, my fault I got the wrong disconnects. I would recommend a ready to go package for the fermentasaurus. I.e spunding valve, picnic tap, co2 reg, correct disconnect, to suit the formentioned, and associated adapters I have seen a lot of people on social media asking what items they need if they purchased the saurus

    Subscribe

    Keg Size Guide
     Vessel Name (Volume) Height Diameter 330ml Bottle Equivalent 
    "Bieber" (2L) 20cm 13.5cm

    6

    "Growler" (2L) - Insulated 30.5cm 13 cm 6
    "Johnson" (4L) 33cm 13.5cm 12
    "BBW Growler" (4L)- Insulated 35cm 15.5cm 12
    "Choad" (5L) 26cm 17.5cm 15
    "Mandingo" (10L) 50cm 17.5cm 30
    "Dominator" (19L) 63cm 22cm 57
    "UniTank" (35L) 90cm 38cm Up to 90
    Build Your Own Mini Keg